![]() At the bottom of the window shows how much memory you have available and also what you have used. You can click on tiles to select them or marquee a selection here I have selected the complete map.In this example, we have chosen Arizona Topo: In the upper left of the window you should see a pull down menu where you select the map set you want.If you see a screen like the one below you might want to check that you have the correct data card in the reader before you wipe out anything you might need later:.Select your GPS or card reader and click Continue.MapInstall will not make it past the second page unless you do this or if you are installing to a card reader, you will want it plugged in and the card mounted. First off, plug your GPS into your Macintosh and have it turned on.Once you have the maps on the GPS you can follow this tutorial to show how to hide and show different maps. You will get a success message at the end similar to: “The data has been successfully sent”.MapInstall will now build the map sets and send them to the GPS unit or memory card depending on which you selected.The next screen will tell you what maps are going to be loaded.Select the segments you want from each map and then click Continue. You can now switch maps at the bottom.Note: Older GPS units have a 2025 map/segment limit and will only read 2gb of card data so be sure to watch that. This will update the amount of space bar left at the bottom. To unselect segments click and drag with the right mouse button. Selected segments will outline in yellow while being selected and be outlined in black with a blueish tint when selected. To select the parts just click and drag across the map.At the bottom of the new window you can select each map that you want to load pieces of. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |